Thanks a lot lot dear Jens.
I was also thinking that without any load I can't get any value of current and you confirmed that. Thanks a lot for removing my confusion.
I am working on a generalized harvestor which can power any of the Ultra Low Power Mems Sensors, Circuit or any Microelectronics. In output I want Power or Power Density or such results related to generalized harvestor.
For overview: If you just view Table 1 in the paper:
Microelectromechanical systems vibration powered electromagnetic generator for wireless sensor applications Koukharenko Beeby Tudor
Although paper is a bit complex but I just have to go for the simple case, probably attaching any micro-sensor (since I dont have have the sensor in practical, also please suggest what load I should attach) and check the value of CURRENT and POWER corresponding to that. Since my concern is not to fabricate the device and check the results practically, I just have to simulate it.
I didn't imagine before taking that project that it is going to be so complex... :(
Or if you already have any .mph file for any case, can u please attach it here, since I feel I am taking too much time of yours.
Thanks again for your help and probably only help I am getting from someone.
Regards
I was also thinking that without any load I can't get any value of current and you confirmed that. Thanks a lot for removing my confusion.
I am working on a generalized harvestor which can power any of the Ultra Low Power Mems Sensors, Circuit or any Microelectronics. In output I want Power or Power Density or such results related to generalized harvestor.
For overview: If you just view Table 1 in the paper:
Microelectromechanical systems vibration powered electromagnetic generator for wireless sensor applications Koukharenko Beeby Tudor
Although paper is a bit complex but I just have to go for the simple case, probably attaching any micro-sensor (since I dont have have the sensor in practical, also please suggest what load I should attach) and check the value of CURRENT and POWER corresponding to that. Since my concern is not to fabricate the device and check the results practically, I just have to simulate it.
I didn't imagine before taking that project that it is going to be so complex... :(
Or if you already have any .mph file for any case, can u please attach it here, since I feel I am taking too much time of yours.
Thanks again for your help and probably only help I am getting from someone.
Regards